The application principle and correct operation method of cable cutters?

Cable shear is a portable pneumatic tool that uses an electric motor as the driving force to carry out cutting work according to the working head of the transmission mechanism driver. It has a simple structure and simple operation. Below, we will introduce the application principle and correct operation method of the offline cable shear?
There are actually many related issues involved in the use of cable cutters. Let's take this opportunity to provide a detailed introduction for everyone. Firstly, the working principle of the cable cutter is that its electric motor is based on the camshaft mechanical structure of the reducer driver. This will cause the boring cutter to push the upper blade for repeated motion, while the lower blade is fixed on the cutting table without moving. And its power plug is a double core protective wire sleeve flexible cable, which cannot be reconnected with a single column vulcanized rubber plug. When using cable cutters, the cut chain link is first placed in the chain link groove, and then high-pressure liquid is injected into the cylinder. Under the action of hydraulic pressure, the plunger pushes the moving knife to move, forming a shear force with the static knife to cut the circular chain. Secondly, it is also necessary to master its correct methods. Charge the battery for 5 hours before cutting the cable. If charging the battery, it must take 12 hours. Users must also accurately grasp how to use cable cutters, and it is important to know that the application of cable cutters will be a rational temperature production and processing category. The temperature of plastic granulation should be well controlled to be close to this temperature range.
Furthermore, the cable cutter should actually have a moderate speed adjustment, as some plastics contain fortifiers such as glass fiber minerals or other fillers. So when operating, you must understand that the friction force of these substances on metal materials is often much greater than that of melted plastic. Therefore, when using cable cutters, it is recommended that everyone also pay attention to the issue of rotational speed. This will greatly improve the efficiency of cable supervision work. Before using the special tool for cable cutting, unplug the charging head plug and disconnect the connection between the special tool and the charging head, as it is not easy to work when connecting the special tool to the charging head. As long as you follow the correct method of operation, then there will be no future problems. And then remove the blade guard sleeve. If you choose manual mode, it is recommended to turn on the switch power supply. Before gradually cutting, let the cutting edge run at full load for a few seconds and listen for any noise, slow or fast conditions.